Teethy Tiki
34
Likes
620
Downloads
991
Views
Published on February 11, 2013
Description
Yes, Yet another Tiki.
I wanted a more festive happy tiki for
demo prints.
I am adding 3 versions in cup form
(the ones ending in holo)
or if you prefer print 0% infill and no top on the original "solid" version.
I wanted a more festive happy tiki for
demo prints.
I am adding 3 versions in cup form
(the ones ending in holo)
or if you prefer print 0% infill and no top on the original "solid" version.
Instructions
0% infill and 2 shells
ABS
240 degrees
.27 slice
80mm/sec
ABS
240 degrees
.27 slice
80mm/sec
You must be logged in to post a comment.
License
Teethy Tiki by cerberus333 is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from cerberus333
More from Decor
Any chance of a hollow version I could make into a pencil holder?
I can make a "hollow" one,
alternately you can print with 0% infill and 0 top levels (top is flat)
I'll make a hollow one but i personally think the 0% method is superior.
(assuming that the slicing software doesn't make strings internally)