Loading

Bagfix

by 3Design3, published

Bagfix by 3Design3 Feb 11, 2013

Description

This is to fix a partly broken school bag (but might be used for any bag of similar size and material

More from Parts

view more

Tags

License

Bagfix by 3Design3 is licensed under the Creative Commons - Attribution license.

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

This thing I created because my daughter's school bag was partly broken and instead of waiting to have it totally broken (and buy a new one), I hope this support will hold it together well.
If you print it out in 1:1 size, the screw holes fit exactly with the M3 screws you might have left from your Ultimakter building pack :-)
As the initial printing of the screwholes caused trouble (the fan wind blew them away), I added a slight closing layer which you must hole-punch before using the thing.
For the two outermost screws you need two M3 nuts, for the other six of them you need no nuts - you just screw them through the T-sized part (from inside the bag) through the back, into the small tubes of the rectangle-sized part.

As you might see on the picture, the parts bent while printing - I have no solution for that, but in the end this had no effect on the practical use. But if you got a solution how to prevent them from bending please post it here.

Comments

You must be logged in to post a comment.

Top