Loading

X Ends & Endstops - For 3 Hole Leadscrew Nuts

by UltiBots, published

X Ends & Endstops - For 3 Hole Leadscrew Nuts by UltiBots Feb 11, 2013

Description

X Ends & Endstops - For 3 Hole Leadscrew Nuts

Visit ultibots.com for MendelMax Kits, Printed Parts, Filament, Electronics, and More...

Recent Comments

view all
Both. Use a pair of 8mm rods for X gantry and a pair of 10mm rods for Z.
http://www.ultibots.com/misumi-precision-ground-10mm-x-405mm-shaft-pair
http://www.ultibots.com/misumi-precision-ground-8mm-x-445mm-shaft-pair
Are these for 8 or 10mm rods?
do you guys carry the darlin and leadscrew? i dont' see it listed on the web site

More from 3D Printer Parts

view more

Liked By

view all

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

Requires standard X End hardware except:
M3x16 Bolts (x6)
M3 Jam Nuts (x6)
Are these for 8 or 10mm rods?
Both. Use a pair of 8mm rods for X gantry and a pair of 10mm rods for Z.
http://www.ultibots.com/misumi-precision-ground-10mm-x-405mm-shaft-pair
http://www.ultibots.com/misumi-precision-ground-8mm-x-445mm-shaft-pair
do you guys carry the darlin and leadscrew? i dont' see it listed on the web site
Without the bushings on one end I don't think these are "bind-reducing" anymore.
You're right. Changed the description. - Brad
Finally! No adapter necessary. Thanks B-rad.
Top