MClamp - Fully Printable Bar Clamp
by mdietz, published
this is a printable bar clamp, derived from my my son's toy bar clamp. Full functional.
Up to 120mm clamping capacity.
the model is without threads. You either need a thread cutter or add threads to the openscad model before printing.
I printed it with 30% infill and it came out quite good. used a thread cutter to cut the thread in the two holes and in the bolt with the handle and small bolt.
Tip: Try out GCodeSimulator to check your print upfront
On Thingiverse: http://www.thingiverse.com/thing:44286
Liked ByView All
Give a Shout Out
MClamp - Fully Printable Bar Clamp by mdietz is licensed under the Creative Commons - Attribution - Non-Commercial license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
We're sure mdietz would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).