by Replicantnexus7, published
This is a head bust of the alien gray, as they were first described in the 60's. A separate base is included. Initially, to be printed together with a dual extruder but the gcode wouldn't build. Might have been some setup problems.
This was my fourth print try and the most complete without some banding. I do these circular type things mirrored upside down on the plate, with a raft and external supports picked. I came across a setting to make the first layer at 225 degrees, then the rest at 220. I have a no-heat plate, and found I can use blue tape (no heat so Kapton tape isn't required) and a spritz of Aquanet hairspary, but it works awesome. I am passing this along because this wasn't the case a couple days ago and this is new find how good this is. It is just the right amount of tackiness, but very releasable, with a firm pull or with a dull putty knife. Moving on to trying larger and more complex outputs.
Liked ByView All
Give a Shout Out
Alien Grey by Replicantnexus7 is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving Replicantnexus7 a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure Replicantnexus7 would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).