by Techno35, published
Recent Commentsview all
I have not forgotten about this thing! I wanted to let you know that the base is completed and some of the upper pad, I will upload samples soon, I do not know if they will print but I have tried to keep it around the 200mm mark on all the individual components. When assembled the total size should be around 350mm-400mm on the z and 200mmx200mm x,y
Wow, it is looking great! I was working on a malp as well, the DHD wia giving me such a headache I had to stop working on it for a long while. I now have the base for the dhd about 90% complete and the Malp is about 40%-60% completed. Your M.A.L.P. is looking great!
Liked Byview all
Give a Shout Out
Original Design by MikoÃÂÃÂÃÂÃÂ ÃÂÃÂ¢ÃÂÃÂÃÂÃÂaj FabjaÃÂÃÂÃÂÃÂ ÃÂÃÂ¢ÃÂÃÂÃÂÃÂski downloaded from 3d Warehouse for Google Sketchup 8.
Used with permission From MikoÃÂÃÂÃÂÃÂ ÃÂÃÂ¢ÃÂÃÂÃÂÃÂaj FabjaÃÂÃÂÃÂÃÂ ÃÂÃÂ¢ÃÂÃÂÃÂÃÂski.
This is an attempt to make a somewhat working model of the Dial Home Device (DHD) to work in conjunction with the thing thingiverse.com/thing:39976 By Glitch. Feel free to use and edit at will and remember to give credit to the original designer.
The changes I made consisted of removing the solid spaces between the Gliphs.
Creating a solid base and putting holes for running wires for LEDs, contact plates, and hopefully running wired to the stargate thingiverse.com/thing:39976 By Glitch.
Perhaps someone could use an Arduino to tie the two things together and make the Corresponding Gliphs on the DHD and the stargate light up in sequence when the Gliphs are pressed on the DHD???
Currently, only the outer ring of Gliphs/Chevrons are moveable.
I believe this thing can be printed as shown, although there may be need of some support under the gliphs? Current footprint is 200mm x 200mm
I am still working on the top and expect to start work on the base of the DHD soon. I have alot of time to accomplish this but it still is very tedious.
Any and all comments and suggestions are most welcome.
I have upload the SKP and STL file formats.
Please keep in mind that I am an ameteur Designer. :)
Uploaded new SKP and STL files
DHD Test 9C STL and SKP are the main DHD
DHD Inner Bottom Cover and DHD outer Bottom Cover are covers for easy access for wiring and LEDs and contact points for on/off switches for LEDS
02-15-13 16:40 CST.
okay folks, new files upload with some pretty good fixes done to them.
1 I split the DHD into layers for easier printing
2 Uploaded the newer files (I left the older files for those who want the entire unit)
Files as follows:
b. Gliph pad 1.stl
c. Gliph pad 2.stl
d. Inner base cover.stl
e. Outer Base Cover.stl
f. DHD Components Assembled.stl
Oopps, I discovered a flaw in the gliph pad 2.stl. The decoration on the top half is not connected. Will repair as soon as possible.
You must be logged in to post a comment.