Thin Wood Veneer - Interactive Build Plate Levelling - Print Aid
by Fused3D, published
Thanks to whpthomas and his thing: http://www.thingiverse.com/thing:39430
This print uses www.fused3d.com Cherry Wood Filament (LAYWOO-D3 1.75mm), which is PLA compatible (No heated bed)
I was able to level my print bed with awesome results on the Replicator2! The print uses the leveler thing plus whpthomas Rep2 ReplicatorG 200 micron profile.
So this specific print I believe is .1mm thick (don't think you can make real wood veneer this thin). You can see through to the grain in the underlying bamboo flooring
The Veneer sheet feels a little rough, almost like finger prints but just slightly rougher.
If you see the tape/acrylic through the veneer, then you bed is too low, and if it stops sticking (strings) then its too high.
Also, I edit the anchor wait time to P6000 (instead of 2000) it seems that makes a difference at the start of a build to get the wood flowing.
Liked ByView All
Give a Shout Out
Thin Wood Veneer - Interactive Build Plate Levelling - Print Aid by Fused3D is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure Fused3D would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).