Z and Y endstops for 8mm +M8 rods
4
Likes
258
Downloads
507
Views
Published on February 13, 2013
Description
My Z endstop worked well once I calibrated the machine -BUT- every time you slightly hit the endstop the Z calibration was gone du to a jiggling holder.
So: I designed this one with some additional mm of guidance on the 8mm rod.
Diameters:
3.5mm (2x M3 screws for clamping)
2.5mm (2x M2 screw for endstop; 10mm dist.)
...you can also glue your endstop to your holder if you don't get M2 screws.
So: I designed this one with some additional mm of guidance on the 8mm rod.
Diameters:
3.5mm (2x M3 screws for clamping)
2.5mm (2x M2 screw for endstop; 10mm dist.)
...you can also glue your endstop to your holder if you don't get M2 screws.
Instructions
If you do not have something to print at the same bunch print at least 2 of them due to the heat of your printed filament and the thin wall width. (Of course you only need one....)
To remove all knobs caused by printing use a 8mm drill to remove them!
Thanks by the way to rrhb for the y endstop!
thingiverse.com/thing:15683
To remove all knobs caused by printing use a 8mm drill to remove them!
Thanks by the way to rrhb for the y endstop!
thingiverse.com/thing:15683
License
Z and Y endstops for 8mm +M8 rods by MLworx is licensed under the Attribution - Creative Commons license.
More from MLworx
More from 3D Printer Parts
You must be logged in to post a comment.