Modified X_Ends for Quick-Fit and Mendelmax 1.5
5
Likes
248
Downloads
682
Views
Published on February 13, 2013
Derived from
Kühling's x-ends for MendelMax 1.5
by tommyc
Description
This is a modified X-end thingiverse.com/thing:21122 set for using RichRaps Quick-Fit X Carriage. thingiverse.com/thing:19590
Motor was moved out 7.5mm to align belts.
Idler was moved out also to align double bearings.
This set uses std 8mm threaded shafts, 10mm Z shafts LM10UU, 8mm X Shafts.
Replaced files with fixed STL's.
Motor was moved out 7.5mm to align belts.
Idler was moved out also to align double bearings.
This set uses std 8mm threaded shafts, 10mm Z shafts LM10UU, 8mm X Shafts.
Replaced files with fixed STL's.
Instructions
I have not printed yet but should align belts with RichRap's Quick-Fit X Carriage.
You must be logged in to post a comment.
Spk64
on
February 15, 2013
said:
Printed a set of the v2 and did not have any problems. The flat bottom makes it much easier.
Spk64
on
February 14, 2013
said:
Just tried printing original version in PLA. Did not like the results with all the urved bottoms. Created V2 with a flat bottom and will print those later.
License
Modified X_Ends for Quick-Fit and Mendelmax 1.5 by Spk64 is licensed under the Attribution - Share Alike - Creative Commons license.
More from Spk64
More from 3D Printer Parts
I'm printing it now. :-)