9v Flashlight Housing by langfordw

printable flashlight housing detail
expand image details printable flashlight housing detail

renderedflashlight
expand image details renderedflashlight


expand image details


expand image details


expand image details


expand image details

Description

I decided to have a go at designing something 3D. This is a case for a simple 9v flashlight that uses a 9v battery, two 5mm LED's, a resistor, and a switch. It uses a snap joint to join the two parts.

I'm not good with blender at all so I did it with Autodesk Inventor. You'll probably have to play with the orientation and stuff so that it will be printable.

--EDIT--
I removed the snap joint because I found it wasn't very printable (at least the way I had it) so the top just fits quite snugly on the bottom.

Instructions

If your using super bright white LED's you can use something like a 470 ohm resistor in series.

Required Tools

Other People's Copies

printable flashlight housing
By: langfordw

Discussion

Downloads

ledcasev3.stl

258 kb / 201 downloads

download

maincasev3.stl

76 kb / 207 downloads

download

ledcasev4.stl

717 kb / 209 downloads

download

ledcasev4 export.gcode

1019 kb / 283 downloads
There was a problem rendering this file.

download