Miniature Wine Glass
by g_koch, published
A miniature wine glass to show off single shell prints. Between printing and photographing the glasses pictured, I had to replace my hard drive, losing the original .stl. I remade it and checked out the gcode to make sure the main aspects (two shell stem, single shell bowl, reasonable base) were retained. I have not yet had a chance to print this, however.
Mine was printed at 30mm/sec, .2mm layer height, 20% infill (for the base), 2 vertical shells (slic3r seems to understand that the bowl should be only one shell thick), 1.75mm PLA. These are nicer when printed with a slightly translucent PLA.
I recommend printing at least four glasses at the same time. Any less and they will not have a chance to cool down. If you see your print start to fail (stem breaks or base unsticks) you can let it run and get some neat "art."
Liked ByView All
Give a Shout Out
Miniature Wine Glass by g_koch is licensed under the Creative Commons - Attribution - Non-Commercial license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
We're sure g_koch would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).