Loading

Single piece peg-top! easy to print and customizable!

by carlosgs, published

Single piece peg-top! easy to print and customizable! by carlosgs Feb 13, 2013

Description

The title is pretty descriptive :)

Printing the vertex of the top flat makes it easy to get a nice finish!

No support required :)

Recent Comments

view all

Thanks to Obijuan and MathForum (http://mathforum.org/library/d... now the peg-top is very easy to parameterize.
You can specify the maximum "air-printing" angle of your printer and it will generate the optimal peg-top :)

The community is here to help you

I have just sent you a fully parameterized peg-top ;-)

More from Mechanical Toys

view more

Instructions

Download, print, spin.

Important note: Keep the perimeter speed low in order to get a nice finish for the overhangs.

Print settings for Cura: 0.5mm nozzle, Wall Thickness: 1.5mm, Layer Height: 0.4mm, 50% infill, 12mm/s (perimeters), 60mm/s (infill).
These speed settings are achieved by choosing a Print Speed of 60mm/s and setting to 20% the inner/outer wall speed on the printing interface.

Thank you Obijuan for fixing it!! :-)

Comments

You must be logged in to post a comment.

carlosgs on Feb 16, 2013 said:

Thanks to Obijuan and MathForum (http://mathforum.org/library/d... now the peg-top is very easy to parameterize.
You can specify the maximum "air-printing" angle of your printer and it will generate the optimal peg-top :)

obijuan on Feb 14, 2013 said:

The community is here to help you

I have just sent you a fully parameterized peg-top ;-)

Top