Loading

Safe T Bagel

by poetryinmotion, published

Safe T Bagel by poetryinmotion Feb 13, 2013

Description

Cool tool to safely cut your morning bagel with even the dullest of knives. Just pop or cram said bread into the top, use the small slot to guide the knife all the way to the end of the cut. It can be used to cut kaiser rolls for you non-bagel types

Recent Comments

view all
It took my Replicator 1 approximately 17 hours to complete. The result was a perfectly sized, sturdy and safe tool for cutting bagels. It's awesome! Thank you.
cubex STL shows 17hours OUCH!!!
Mine is printing as I'm writing this on my Replicator2. I'm printing 3 shells 10% and 0.1mm so far it's been printing for 26 hours and it's just at 67%. It is big but holding a bagel up to it while it's printing and the size looks spot on. I did have to resize in MakerWare to maximum which did reduce the size slightly but as I said holding the bagel up to it and it looks fine. I'll post some pics tomorrow, if it's finished.

More from Kitchen & Dining

view more

Makes

Liked By

view all

Tags

License

Safe T Bagel by poetryinmotion is licensed under the Creative Commons - Attribution license.

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

Again, feedback is important, If there is an issue with this non tested item we want to know.
It took my Replicator 1 approximately 17 hours to complete. The result was a perfectly sized, sturdy and safe tool for cutting bagels. It's awesome! Thank you.
cubex STL shows 17hours OUCH!!!
For you non-bagel types? LOL! What you talkn bout Willis? This could be the most useful Thing ever created with a 3D printer!
According to my slicer this will take 13 hours to print. Before I go ahead with it, are you sure you have the size right? It does look awfully big in my preview.
Mine is printing as I'm writing this on my Replicator2. I'm printing 3 shells 10% and 0.1mm so far it's been printing for 26 hours and it's just at 67%. It is big but holding a bagel up to it while it's printing and the size looks spot on. I did have to resize in MakerWare to maximum which did reduce the size slightly but as I said holding the bagel up to it and it looks fine. I'll post some pics tomorrow, if it's finished.
Top