by mooses, published
I was looking for some specific alien figurine to buy...unfortunately there are none available for some reason. So I made one myself.
Printed it on my my trusty solidoodle 2 with the 0.3mm profile in slic3r, modeled with Silo 2.
Recent Commentsview all
I printer Roger at 50% with a couple of different plastics. Had a few issues with the lower butt area, but overall quite nice. Used a Replicator 2 at 100 microns. Right now doing a Roger with glow in the dark plastic.
I've printed Roger without support from small to big. It left a few strings at the bottom/butt. No visible marks left. Small = 3 cm high and biggest 20 cm tall both at 60 micron. Thanks for sharing. Been looking for Stan but I can't find him either.
Liked Byview all
Give a Shout Out
Scale down on your own risk, the neck and arms are already quite narrow.
Use artist tape to mask the eyes, then spray this sexy alien with some gray spray (e.g. montana Black "Mouse") then paint the pupil cavities with some black sharpie.
You must be logged in to post a comment.