Flower
49
Likes
1527
Downloads
2776
Views
Published on February 14, 2013
This thing was Featured on February 14, 2013
Description
A printed flower, made for my Wife.
Instructions
Print 2 bud half's and a stem and press/glue together.
I have tested this with Cura Daid on a RepRapPro printed at 0.1 layer height, 20% infill with 3 perimeters with Faberdashery PLA. I had to slow the print way down on the final few layers to get the rim to finish correctly so make sure your minimum layer time is like 10 seconds.
I have tested this with Cura Daid on a RepRapPro printed at 0.1 layer height, 20% infill with 3 perimeters with Faberdashery PLA. I had to slow the print way down on the final few layers to get the rim to finish correctly so make sure your minimum layer time is like 10 seconds.
You must be logged in to post a comment.
Caboose
on
February 15, 2013
said:
This printed quite well in ABS. Some holes, but I attribute that to 10% infil vs 100%. See my photo in the "Made" section. Very nice!
Anonymous
on
February 15, 2013
said:
I suddenly lost my wife one week ago today and I will print this and put it in a printed vase for her as she really loved 3d printers.
thecrazy
on
February 14, 2013
said:
Do you have the full bud uncut? with a brim it would print in one piece.
License
More from markab
More from Sculptures
Added a full bud version