Loading

Smart phone stand

by engphysguy, published

Smart phone stand by engphysguy Feb 14, 2013

Description

A basic Smart phone stand that will hold most Smart phones in a horizontal or vertical position. I designed the stand to accept a Google Nexus in an OtterBox but it will hold anything of similar size.

Recent Comments

view all

Nice model. Was super simple to print. 1 Con: Won't hold and iPhone 6 vertically, due to balance. 1 Suggestion: I wish it had an easy (near) horizontal surface to customize with logo/text in a 3d modeling pgm (I use OpenSCAD).

simply and good? but can use for just small phone.

Currently watching this print and it's looking good. One point though - this didn't need to be so solid, it could have a large hole in the back for example to print faster and use less material. That hole could also be used for a charger cable if the lowest point was about 5mm higher.

More from Mobile Phone

view more

Liked By

view all

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

Build and enjoy.

N.B. A few cell phones seem to tip the stand when standing vertical. I am re-engineering the base to correct this.

Nice model. Was super simple to print. 1 Con: Won't hold and iPhone 6 vertically, due to balance. 1 Suggestion: I wish it had an easy (near) horizontal surface to customize with logo/text in a 3d modeling pgm (I use OpenSCAD).

simply and good? but can use for just small phone.

Currently watching this print and it's looking good. One point though - this didn't need to be so solid, it could have a large hole in the back for example to print faster and use less material. That hole could also be used for a charger cable if the lowest point was about 5mm higher.

Top