Wildcat
9
Likes
93
Downloads
456
Views
Published on February 15, 2013
Description
Instructions
I went extreme on this to see if it would print ok
0% infill
1 shell
.27 slice
80mm/sec
240 degrees
ABS.
Weight 22.1 grams
I had a few small holes on the nose, cheek, near ears and back of head.
ABS/Acetone goop to the rescue 1 minute of dab and wipe and It's looking decent.
this is a really thin and light print that printed in under an hour for a really reasonably
sized print.
############################################3
ReplicatorG crashed on the original stl i posted
reposted with stl that sliced sucessfully
0% infill
1 shell
.27 slice
80mm/sec
240 degrees
ABS.
Weight 22.1 grams
I had a few small holes on the nose, cheek, near ears and back of head.
ABS/Acetone goop to the rescue 1 minute of dab and wipe and It's looking decent.
this is a really thin and light print that printed in under an hour for a really reasonably
sized print.
############################################3
ReplicatorG crashed on the original stl i posted
reposted with stl that sliced sucessfully
You must be logged in to post a comment.
License
Wildcat by cerberus333 is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from cerberus333
More from People
Nice, man! Glad to see it posted. This is the guy that trained Black Canary, right?
In one of his "incarnations" i recall a storyline like that.
I just liked the look of the character.
Thought it would be cool to make.