ORCA 0.43 carryhandle
1
Likes
66
Downloads
453
Views
Published on February 15, 2013
Description
I had the need to carry my ORCA around. To make it a little bit easier, I designed this grips for it.
Instructions
You need to extend the two threaded rods for about 2cm. I have used adapters and two 8mm screws for the extension.
License
ORCA 0.43 carryhandle by JackT is licensed under the Attribution - Share Alike - Creative Commons license.
More from JackT
More from 3D Printer Parts
You must be logged in to post a comment.