Mjolnir(Thor's Hammer) Necklace
8
Likes
92
Downloads
959
Views
Published on February 15, 2013
Description
I made this using 3d heightmaps of a mjolnir image I found online. I printed it in glow-in-the-dark PLA and wear it on a steel chain.
The original STL was so detailed that my Slic3r just couldn't handle it. I had to decimate it 90% using blender and fix the holes this generated in netfabb. In the end though, I'm very pleased how it turned out!
The original STL was so detailed that my Slic3r just couldn't handle it. I had to decimate it 90% using blender and fix the holes this generated in netfabb. In the end though, I'm very pleased how it turned out!
Instructions
This will slice with slic3r but it literally takes hours so don't give up. The print shown was printed at 600%. Rep your viking norse gods and 3d printing at the same time.
If you want to buy one of these necklaces check out my shop etsy.com/listing/123735525/mjolnir-thors-hammerglow-in-the-dark
If you want to buy one of these necklaces check out my shop etsy.com/listing/123735525/mjolnir-thors-hammerglow-in-the-dark
Collections
Parada
by Azra
Interesting but will not fit into other catagories
by Gernreich
Cool Stuff
by CodeAndReload
License
Mjolnir(Thor's Hammer) Necklace by gungn1r is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.