by Thinkinglink, published
This was a rose printed for my wife as part of her Valentine's Day gifts.
This model can still use some work as the polygons for the petals should be thicken a bit for better prints. I will try to find time to make those fixes and update this model in the future.
In the meantime, enjoy some roses :)
Recent Commentsview all
Liked Byview all
Give a Shout Out
I've only got one test of each flower for this model. the rose_open was printed at 100% fill, the stem was at 50% fill, and the rose_closed was printed at 10% fill. there isn't much difference exterior wise, the gcode combines some of the pedals and makes them thicker than the original model.
I haven't tired printing the leaves yet. It will probably require some support.
the stem and the flower i super glued together. just a dab in the center.