Fuji Instax Photo Frame
by jameswood, published
This frame is printed in one piece. The photos slot in from behind, and are securely held without damaging them. The support "beams" could be used to attach fridge magnets or double sided tape, or the frame can be hung over a nail.
The photos are held in place by grooves along each edge, which are printed as 45Â° overhangs to avoid any dramas.
Recent Commentsview all
I have thought about it, yes! I don't think it'd be too hard. It was made in Sketchup. If you don't have a copy, you should grab one! It's pretty good. Adapting this could be a good project to get to know it with!
This is fantastic. I was wondering whether you had thought about making a similar design for a classic Polaroid photograph. Would it be easy to alter this design's dimensions? I'm relatively new to 3D modeling and printing so any pointers would be greatly appreciated!
Liked Byview all
Give a Shout Out
You must be logged in to post a comment.