Solidoodle 2 bed leveling thumbscrew
2
Likes
120
Downloads
396
Views
Published on February 16, 2013
Description
I converted by Solidoodle 2 to use glass on the bed, and a modification is needed to be able to level the bed while the glass is on the bed. The alternatives I found required gluing, so I created this thing which doesn't need that.
Instructions
Print 3x thumbscrews.
Screw one M4 nut into each leveling screw, add the thumbscrew and screw one M4 nut below the leveling screw.
Hold the thumbscrew and tighten the bottom M4 nut to lock them in place (use locktite if needed)
Enjoy!
Screw one M4 nut into each leveling screw, add the thumbscrew and screw one M4 nut below the leveling screw.
Hold the thumbscrew and tighten the bottom M4 nut to lock them in place (use locktite if needed)
Enjoy!
License
Solidoodle 2 bed leveling thumbscrew by krist10an is licensed under the Attribution - Non-Commercial - Share Alike license.
More from 3D Printer Accessories
You must be logged in to post a comment.