GrooveMount 90° Bracket for Birdstruder
1
Likes
72
Downloads
441
Views
Published on February 16, 2013
Description
I needed a bracket to rotate my Birdstruder on my MendelMax 90° so I could enjoy the full print bed area. I designed this bracket, and these files are the result.
It was designed for the MakerGear GrooveMount system, so it will work with MakerGear, J-Head, or any other hot end that is compatible with the GrooveMount system.
This was only designed with the Birdstruder and Simonious' Supa-Flat X-Carriage in mind. If you are not using these two parts, I can't guarantee it will work right for you.
It was designed for the MakerGear GrooveMount system, so it will work with MakerGear, J-Head, or any other hot end that is compatible with the GrooveMount system.
This was only designed with the Birdstruder and Simonious' Supa-Flat X-Carriage in mind. If you are not using these two parts, I can't guarantee it will work right for you.
Instructions
Laser-cut out of 3/16" plywood, attach with M4 socket caps and enjoy more print room!
License
GrooveMount 90° Bracket for Birdstruder by Ember is licensed under the Attribution - Share Alike - Creative Commons license.
More from Ember
More from 3D Printer Parts
You must be logged in to post a comment.