iPhone 4s Slim Case Blank
by MakerBobDesigns, published
I have downloaded a few iPhone cases and all of them have fit issues, or are hard for the slicers to get to print properly. I made this case to fit an iPhone 4s super snugly and it is pretty thin and easy to print with no support. I am using this as a bed for some additional hardware (gears so far). This is just a nice blank place to start. Enjoy!
Print this with:
.20 mm layers
4 shells total
raftless with no support
230 / 110 temp
80 / 150 speed
You have to slide the top of the phone in first, and then snap the bottom sides around the phone. Removal is the reverse.
Liked ByView All
Give a Shout Out
iPhone 4s Slim Case Blank by MakerBobDesigns is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure MakerBobDesigns would love to see what you've printed. Please document your print and share a Make with the community.