Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Dual-chambered Bong
1
Likes
138
Downloads
627
Views
Published on February 18, 2013
Description
This is a nice 'utensil' that has 2 separate water chambers for extra-smooth enjoyment.
Instructions
Print.
Add an 11mm slider.
Hit.
Hit.
Pass.
I have not printed this since I added the baffles, but I have printed the body of it, and it works pretty nicely.
Print in PLA with 10% fill and 2 extra layers, for waterproof-ness.
I also included the rather sloppy OpenSCAD file... (Feel free to clean it up a bit)
Add an 11mm slider.
Hit.
Hit.
Pass.
I have not printed this since I added the baffles, but I have printed the body of it, and it works pretty nicely.
Print in PLA with 10% fill and 2 extra layers, for waterproof-ness.
I also included the rather sloppy OpenSCAD file... (Feel free to clean it up a bit)
License
Dual-chambered Bong by GoolGaul is licensed under the Attribution - Share Alike - Creative Commons license.
More from GoolGaul
back in the day, I had one with 4 water chambers, each was a small beaker. you really couldn't get a good pull on it. I added a glass dome over the bowl and connected in a big fish-tank air pump and not only did the smoke flow, but it was icy cold too...