YAFEH (Yet Another Friggin' Earphone Holder)
6
Likes
248
Downloads
1057
Views
Published on February 18, 2013
Description
Does Thingiverse really need another earphone holder? I'm afraid so. I've printed at least a dozen designs out there and they're either 1. Too small, 2. Too specific to a brand, or 3. Too fragile. So, I fired up Tinkercad and did my own design.
Instructions
Easy to print, this holder should handle buds of any size, cords of any length (with or without controls) and should readily withstand your backpack.
Press-fit the bottom to the core (or glue if needed) and use a small screw to fasten the lid.
Just added a v2 of the bottom with a bit more reinforcement. Had one sleeve snap off during assembly.
Press-fit the bottom to the core (or glue if needed) and use a small screw to fasten the lid.
Just added a v2 of the bottom with a bit more reinforcement. Had one sleeve snap off during assembly.
You must be logged in to post a comment.
License
YAFEH (Yet Another Friggin' Earphone Holder) by 3d0g is licensed under the Attribution - Share Alike - Creative Commons license.
Two suggestions
Magnetic hinges / locks
See http://www.thingiverse.com/thi...
might be cool.
And while I haven't tried to print it yet, 45 degree V shapes on the overhangs might ease the print process.
Note the lid has as an internal lip that keeps it closed. Of course it could be removed and holes added for magnets if so desired.
There are no overhangs. If you mean the bridges, any printer should be able to span a 3mm bridge.