Rectangular-ish Quick Release Tripod mount
7
Likes
177
Downloads
473
Views
Published on February 18, 2013
This thing can be customized with MakerBot Customizer!
Open in Customizer
Description
This is to create a replacement Tripod Quick Release. It amazes me how many of these shoes are lost yet the camera and tripod are not.
A lot of these seem to have a 'key' so the plates are not interchangeable when they ought to be able to do so.
There is an easy-access nut recess at the bottom for attaching the shoe to the camera.
This should print as created without support.
A lot of these seem to have a 'key' so the plates are not interchangeable when they ought to be able to do so.
There is an easy-access nut recess at the bottom for attaching the shoe to the camera.
This should print as created without support.
Instructions
Take some measurements, key them into Customizer and print. And a bolt, and you are good to go.
The Velbon VideoMate 607 took about 1 hour and 15 minutes to print.
ShoeBottomWidth = 68;
ShoeBottomLength = 61;
ShoeTopWidth = 68;
ShoeTopLength = 54;
ShoeDepth = 8;
FrontDetentLength = 15;
FrontDetentWidth = 2;
SideDetentLength = 16;
SideDetentWidth = 3;
TopPlateWidth = 78;
TopPlateLength = 69;
TopPlateDepth = 1;
The Hakura S-6000 took about 45 minutes to print.
ShoeBottomWidth = 42;
ShoeBottomLength = 43;
ShoeTopWidth = 42;
ShoeTopLength = 34;
ShoeDepth = 8;
FrontDetentLength = 0;
FrontDetentWidth = 0;
SideDetentLength = 4;
SideDetentWidth = 3;
TopPlateWidth = 50;
TopPlateLength = 54;
TopPlateDepth = 2;
The Velbon VideoMate 607 took about 1 hour and 15 minutes to print.
ShoeBottomWidth = 68;
ShoeBottomLength = 61;
ShoeTopWidth = 68;
ShoeTopLength = 54;
ShoeDepth = 8;
FrontDetentLength = 15;
FrontDetentWidth = 2;
SideDetentLength = 16;
SideDetentWidth = 3;
TopPlateWidth = 78;
TopPlateLength = 69;
TopPlateDepth = 1;
The Hakura S-6000 took about 45 minutes to print.
ShoeBottomWidth = 42;
ShoeBottomLength = 43;
ShoeTopWidth = 42;
ShoeTopLength = 34;
ShoeDepth = 8;
FrontDetentLength = 0;
FrontDetentWidth = 0;
SideDetentLength = 4;
SideDetentWidth = 3;
TopPlateWidth = 50;
TopPlateLength = 54;
TopPlateDepth = 2;
License
Rectangular-ish Quick Release Tripod mount by creuzerm is licensed under the Attribution - Creative Commons license.
You must be logged in to post a comment.