by GigaGremlin, published
After losing Version 5. of my QuadRotor by a strong wind, I have now decided on a Hex, which should be easy to repair.
The base is meant for the NAZA-GPS control and the receiver on Level 2 is for/from a DEVO7.
Instead of screws I use cable ties, except of the 2nd level.
Yuo will need 6x 210mm 10x10mm square tubes, 6x 6x20mm tubes for the 2nd Floor and 6x 40mm Nylon screws to finish the Frame.
Motors, ESCs and Akku are not tested yet but I Hope my S3 will be enough for the Hex and the Camera....
Liked ByView All
Give a Shout Out
GG-Multicopter Frame by GigaGremlin is licensed under the Creative Commons - Attribution - Non-Commercial license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
We're sure GigaGremlin would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).