Bracelet V2
Description
A second attempt at making a bracelet. I used a different technique this time: I created a square, then used the 'Spin' command and extruded it 300 degrees, capped the ends manually, and then scaled it down in the Y axis by about 40% to make it oblong. Much nicer to wear and a bit prettier.
Anyone know how i can round the ends?
Anyone know how i can round the ends?
Instructions
No instructions provided.
You must be logged in to post a comment.
Anonymous
on
May 2, 2009
said:
Y'might want to run a "remove duplicate verticies" command on this one-- I just downloaded it and found lots of 'em.
If that doesn't crash skeinforge it could still be slowing it down quite a bit...
syvwlch
on
May 2, 2009
said:
I know this is not what you want to hear, but if you export it as a .obj file, TopMod will round off the ends in two clicks. :-)
License
Testing this out for a potential derivative design.