PSU Brackets for Prusa
5
Likes
130
Downloads
645
Views
Published on February 18, 2013
Description
With these brackets your power supply stays put beneath the bed of your Prusa.
Instructions
You will need both Brackets. They work with thingiverse.com/thing:30011 and 253mm between the frame vertex feet of your Prusa. If your belt is too low you can use thingiverse.com/thing:51618 to mount your Y steppermotor
The support structure is already in the stl, just cut the bottom where it is thinner, the support parts will break loose.
The support structure is already in the stl, just cut the bottom where it is thinner, the support parts will break loose.
License
PSU Brackets for Prusa by mowi is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from mowi
More from 3D Printer Parts
You must be logged in to post a comment.