Loading
Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!

Bong

by Jewcookie, published

Bong by Jewcookie Feb 19, 2013

Description

This is my design for a Bong. Smoke it! :D

I didn't print it yet but i expect i should make some support in the middle to prevent the top of the sphere collapsing. Busy working on it. :)

Recent Comments

view all
Thnx, glad you like it.

It should be water tight, at least the design is water tight. I haven't printed it since i had to get rid of my printer. I would print it with 100% infill. the walls are not that thick and to make it rigid that would be the best setting i think.
To answer the question on how it is "safe to use", if you use PLA plastic, than PLA is non-toxic and therefore can theoritically be considered not harmful, however obviously any melted plastic in the lungs is never a good idea, so as long as there is something between the plastic and flame than it'll work no different than any other pipe. Awesome design.

My question, Is it water tight? and if so, what kind of infill are you using?
First smoke some, You will not worry about it being safe anymore for some time.

You should just roll a joint. Stick it in the hole and smoke it that way. Not put in some weed in the hole and light it.

More from 3D Printing

view more

Makes

Liked By

view all

License

Bong by Jewcookie is licensed under the Creative Commons - Attribution - Share Alike license.

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

None yet! you can try and print it if you like. :P

To answer the question on how it is "safe to use", if you use PLA plastic, than PLA is non-toxic and therefore can theoritically be considered not harmful, however obviously any melted plastic in the lungs is never a good idea, so as long as there is something between the plastic and flame than it'll work no different than any other pipe. Awesome design.

My question, Is it water tight? and if so, what kind of infill are you using?
Thnx, glad you like it.

It should be water tight, at least the design is water tight. I haven't printed it since i had to get rid of my printer. I would print it with 100% infill. the walls are not that thick and to make it rigid that would be the best setting i think.
I'm not knowledgeable on the subject of bongs, but how would this be safe to use?
First smoke some, You will not worry about it being safe anymore for some time.

You should just roll a joint. Stick it in the hole and smoke it that way. Not put in some weed in the hole and light it.
Drug paraphernalia is OK here, but no weapons? (only a dig at thingiverse, not you)
Guns kill people. Pot/weed doesn't.
Top