Leonardo Robot x TeamTeamUSA
10
Likes
958
Downloads
439
Views
Published on December 20, 2010
This thing was Featured on December 20, 2010
Derived from
Leonardo Robot
by jrombousky
Description
!2 Teams are better than 1!
The derivative feature isn't working correctly so I created this thing until it it's fixed.
This is a derivative of thingiverse.com/thing:1769 that has been modified to become the TeamTeamUSA mascot: a thing with two heads, two arms, and three legs.
The derivative feature isn't working correctly so I created this thing until it it's fixed.
This is a derivative of thingiverse.com/thing:1769 that has been modified to become the TeamTeamUSA mascot: a thing with two heads, two arms, and three legs.
Instructions
Print and clean the files in the Parts List and assemble them using 3mm filament. Use colored filament if you want to accentuate the pivot points.
If the holes are too big, squeeze the filament using a locking plier to increase its diameter. Alternate the squeeze orientation to create a larger diameter 'cylinder' by distributing the squeezes along the filament.
The 'fixed' files are from thingiverse.com/thing:1769 and processed through cloud.netfabb.com and centered using RepG.
If the holes are too big, squeeze the filament using a locking plier to increase its diameter. Alternate the squeeze orientation to create a larger diameter 'cylinder' by distributing the squeezes along the filament.
The 'fixed' files are from thingiverse.com/thing:1769 and processed through cloud.netfabb.com and centered using RepG.
You must be logged in to post a comment.
License
Leonardo Robot x TeamTeamUSA by TeamTeamUSA is licensed under the Attribution - Creative Commons license.
More from TeamTeamUSA
More from Model Robots
This is full of so much awesome.