Parametric Pulley
4
Likes
137
Downloads
486
Views
Published on February 20, 2013
Derived from
Parametric idler pulley
by whosawhatsis
This thing can be customized with MakerBot Customizer!
Open in Customizer
Description
A parametric pulley designed to be clipped on a bearing.
It has flanges to keep the belt in.
It was initially designed to keep off my mendel X-axis belt from the fixed flange.
It has flanges to keep the belt in.
It was initially designed to keep off my mendel X-axis belt from the fixed flange.
Instructions
Parameters are in millimeters except for Flange_Shape which is 1 if you want squared flanges or 2 if you want rounded flanges.
You may have to add a fraction of a millimeter to the Belt_Width to allow some clearance.
I have printed it without any noticeable problem. It fits tightly around the bearing and you'll need a hammer to mount it.
On a reprap, as the flanges make the pulley a bit larger than the bearing, you'll need to add a washer on each side.
You may have to add a fraction of a millimeter to the Belt_Width to allow some clearance.
I have printed it without any noticeable problem. It fits tightly around the bearing and you'll need a hammer to mount it.
On a reprap, as the flanges make the pulley a bit larger than the bearing, you'll need to add a washer on each side.
License
Parametric Pulley by jlp6k is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.