Loading

Toothbrush Throne

by markab, published

Toothbrush Throne by markab Feb 20, 2013

Description

A holder for Oral B electric toothbrush heads.

Recent Comments

view all
hello the scad file is in the downloads. Thanks
Very nice,
I would like to do a 4 site version with small changes (initial letter for the owner and holes for screw it on the wall), is possible to have a step file I can import?
Thanks in advance
Thank you.

More from Bathroom

view more

Liked By

view all

License

Toothbrush Throne by markab is licensed under the Creative Commons - Attribution license.

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

Should print fine with a 0.2mm layer height and 25% infill.

Just noticed that there are different shaped heads that do not fit this holder so I will have to update.

V2 makes a change so more types of Oral B toothbrush heads fit.

V3 is a 4 slot holder by default however the V3 OpenSCAD file allows easier configuration of holder numbers.

Very nice, I would like to do a 4 site version with small changes (initial letter for the owner and holes for screw it on the wall), is possible to have a step file I can import? Thanks in advance

hello the scad file is in the downloads. Thanks

<p>Thank you.</p>

<p>Can you make one with 5 places?</p>

<p>Should be a 5 version up now.</p>

<p>Wasn't sure if I should print it vertically as it's configured or rotate it flat to print. Cura suggested there would be more overhangs if I was to lie it flat so I printed it vertically instead.</p>

<p>I normally print it flat on it's back with a big desk fan cooling and a fairly slow print speed, however I think upright should print fine as well :)</p>

Top