Ultimaker Printhead Cover for Extruder v2.0
23
Likes
171
Downloads
1028
Views
Published on February 21, 2013
Derived from
Ultimaker printhead cover
by Gijs
Description
Gijs created a great cover for the printhead of the Ultimaker. The printer looks much more professional just by adding that thing.
But I found out that Gijs' version is out of date as it doesn't fit for the latest version of the Ultimaker which has an updated extruder (Extruder version 2.0).
So I made an updated version that fits the new printhead very well. My cover also features a small hole at the left side that can be used to 'tunnel' additional cables from the outside into the printhead, e. g. cables from a second fan.
But I found out that Gijs' version is out of date as it doesn't fit for the latest version of the Ultimaker which has an updated extruder (Extruder version 2.0).
So I made an updated version that fits the new printhead very well. My cover also features a small hole at the left side that can be used to 'tunnel' additional cables from the outside into the printhead, e. g. cables from a second fan.
Instructions
As this thing doesn't need to meet any critical mechanical or thermal aspects you can print in PLA. An infill of 20 % is enough.
License
Ultimaker Printhead Cover for Extruder v2.0 by thingster is licensed under the Attribution - Share Alike - Creative Commons license.
More from thingster
More from 3D Printer Accessories
You must be logged in to post a comment.