Prusa i3 PSU Cover + Switch
by oliasmage, published
Use This Project
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
I am upgrading one of my Prusa Mendel printers to use a wooden variant of the Prusa i3 frame.
I wanted to mount a 12V 30A PSU to the right-side brace. I used the convenient 4mm mounts on the bottom of the PSU to do so. See photo.
However, I also wanted to make a PSU terminal cover and switch mount that was easier to print and used less plastic (well, sort of). Additionally, since the PSU was mounted flush, I needed a flush mounted cover so that I wouldn't need to use/make spacers.
Thus, I created two parts; one to cover the terminals, another to house the inlet module. This time I chose an inlet module that mounts with screws.
I hope you can make use of this solution.
(2) small wood screws for inlet module (you can also use m3X5mm)
(2) m3 nuts
(1) power connector and switch like this:
Inlet Module Plug Fuse Switch Male Power Socket 10A 250V 3 Pin IEC320
Note: if you use a different module, you will need to adjust the model.
Adjust the covers in the .scad file to fit your PSU. Print one set of the covers. Route the wires and secure them in place. I found it was easier to mount the inlet module with pig tails first then cut them to length when mounting the terminal cover.
See the .scad file for printing tips.
Mounting the PSU
Measure the spacing of the holes on your PSU. Mine were 50mm x 150mm. Mark the holes on your wood (or similar brace) taking into account the vents on the PSU. Use a 5mm drill bit to make the holes (allows for some wiggle room to make mounting easer). I mounted mine 15mm from the main frame component. Mount the PSU with covers attached. See photo.
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingPrint Fulfilment
Order a print of this ThingTools and Utilities
Repair, slice, or enhance this Thing
Prusa i3 PSU Cover + Switch by oliasmage is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving oliasmage a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure oliasmage would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).