Filament Spool Holder
by spencers, published
A beautiful replacement filament spool holder for the Replicator 2 that holds all size spools (we've bought PLA from MakerBot, Amazon, and MakerFarm - so we 4-5 different size spools). More functional than the one you get with the Replicator 2, and much prettier.
Take the spool holder off of your maker bot, put this one in the same slot the old one came out of. It will tip up at a 5Â° angle to ensure the spool doesn't slide off during a print.
I had success with Replicator 2 print settings set to:
â€¢ Medium Quality
â€¢ 10% fill
â€¢ 3 shells
â€¢ 0.2mm layer height
â€¢ No supports
Liked ByView All
Give a Shout Out
Filament Spool Holder by spencers is licensed under the Creative Commons - Attribution - Non-Commercial - No Derivatives license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is not allowed.
- Commercial use is not allowed.
We're sure spencers would love to see what you've printed. Please document your print and share a Make with the community.