Loading

casting flask kit

by CaptnBlynd, published

casting flask kit by CaptnBlynd Feb 22, 2013

Description

corners for building a casting flask, both drag and cope. For doing sand casting of metals etc.

More from Parts

view more

Liked By

view all

License

casting flask kit by CaptnBlynd is licensed under the Creative Commons - Attribution license.

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

corners for building a casting flask, both drag and cope. The inside bracket has channels that accept 8mm (5/16) rod to use as the ridge. On a very large flask I would put an "U" bolt near the center of the ridge rod thru the side wall to prevent sag. Sized to use 1x4 lumber size (3/4" x 3 1/2" actual dimension) using whatever size lengths you want. Use standard hinges for the snap connectors ( to hold the drag and cope together) by pulling the pin and using a longer pin that is easy to remove then screw or bolt the hinge to the side wall on the outside on opposite sides.
Top