Paper Towel Holder RMX
21
Likes
261
Downloads
545
Views
Published on February 22, 2013
Derived from
Paper Towel Holder
by areeve20
Description
I have the original Paper Towel Holder by
areeve20 printed, but the snap in is broken.
This holder can not break.
Insert roll and push side panel.
If the roll is empty, simply buckling and remove.
areeve20 printed, but the snap in is broken.
This holder can not break.
Insert roll and push side panel.
If the roll is empty, simply buckling and remove.
Instructions
I printed with the following parameters:
0.36 Layer
1 Perimeter
40% Infill
PLA
0.36 Layer
1 Perimeter
40% Infill
PLA
You must be logged in to post a comment.
More from capitaenz
More from Kitchen & Dining
Nice remix!
How do you prevent the buckling piece from working its way out while the roll is spinning?
What part of the snap broke on my design, was it the little parts that flex? I was wondering if PLA would be too brittle for that amount of flex. I would like to use your feedback to make some improvements. - Thanks
Thank you.
I have reduced the diameter of the circle 0.1 mm and polished with sand paper. It is only clamped.
Yes, the flexible part ist broken.
PLA is probably too stiff.