Giant PLA Heart
9
Likes
777
Downloads
931
Views
Published on February 22, 2013
Derived from
PLA Heart Gears for Replicator 2
by whpthomas
Description
This is the GIANT version of PLA Heart! it took nearly 30 hours to print on Rep2, enjoy.
More than a remix it's just a resize!
More than a remix it's just a resize!
Instructions
********************************************************
Update (Firmware 7.2 & Makerware 2.0 Tested!)
Parameters:
Infill: 0%
Shells: 5
Layer: 0.28
*********************************************************
The pins are clearly too tight, they need a little rework.
Load, center on platform and print, thats it.
The final build requires aprox. 700g of pla.
Update (Firmware 7.2 & Makerware 2.0 Tested!)
Parameters:
Infill: 0%
Shells: 5
Layer: 0.28
*********************************************************
The pins are clearly too tight, they need a little rework.
Load, center on platform and print, thats it.
The final build requires aprox. 700g of pla.
License
Giant PLA Heart by maker_workshop is licensed under the Attribution - Non-Commercial - Share Alike license.
More from maker_workshop
More from Sculptures
You must be logged in to post a comment.