Leonardo Voltron
20
Likes
1087
Downloads
665
Views
Published on December 26, 2010
This thing was Featured on December 27, 2010
Derived from
Leonardo Robot
by jrombousky
Description
All the custom bits you'll need to change you Leonardo Robot into a Voltron!
Just a few minutes late for the design challenge! But, I had fun nonetheless!
Just a few minutes late for the design challenge! But, I had fun nonetheless!
Instructions
Print up the all parts from the Leonardo Robot thingiverse.com/thing:1769 by thingiverse.com/jrombousky (relevant parts included below)
Print these Voltron themed parts
Replace the feet, hands, and torso with the Voltron-ified parts
Print these Voltron themed parts
Replace the feet, hands, and torso with the Voltron-ified parts
License
Leonardo Voltron by MakerBlock is licensed under the Attribution - Share Alike - Creative Commons license.
More from MakerBlock
This is so awesome. I want to see it printed.
Honestly, it's just not laid out very well and the STL's also have a bunch of problems. I ended up creating a Voltron model from scratch ( http://www.thingiverse.com/thi... ) from OpenSCAD. It would probably be a lot easier to graft the OpenSCAD model onto the Leonardo Robot you designed than to use the above attempt at Voltron.