13 in percolated water pipe/ bong
16
Likes
1216
Downloads
2832
Views
Published on February 22, 2013
Description
This is a 13in water pipe/bong for smoking medical marijuana. works very well, no problems or leakes.
It features: 9 arm perc tree or 6 arm perc tree,splash guard/ ice catcher, and a diffused stem that fits 14mm bowl/attchment
It features: 9 arm perc tree or 6 arm perc tree,splash guard/ ice catcher, and a diffused stem that fits 14mm bowl/attchment
Instructions
1)Print out parts
2)glue together
3)smoke down
2)glue together
3)smoke down
You must be logged in to post a comment.
hendo420
on
March 19, 2013
said:
Getting all the parts to print off watertight is a challenge with my printer. lol
I have made a few copies of each piece just to get 1 that will hold water. Its my printers fault, not the design I'm sure.
IVIUPPET
on
March 18, 2013
said:
How'd you get the black ring near the bottom as well as the black ring on the end of the stem? Did you use a Replicator 2X with dual extrusion or scale the rim.stl (in a different color) down to fit or what?
Nice job! Best water pipe I've seen yet!
Bdorney
on
March 7, 2013
said:
How long did this take to print all together? And about how much filament was used?
License
13 in percolated water pipe/ bong by TREV is licensed under the Attribution - Non-Commercial - Share Alike license.
More from TREV
Is this healthy? will heating the plastic cause the vapors to be inhaled?
The plastic never gets hot because you add a glass attachment to smoke out of. so it should be just as health as any other plastic bong you can buy