30 teeth MXL plotter pulley up to 10mm belt for reprap
by danithebest91, published
30 teeth MXL plotter pulley for drive any 3D printer with low cost plotter pulleys 8â‚¬/4meters
print at 0.15mm layer height and 90%infill, in the drowing i have considerate the melt plastic distortions, i have printed 3 at time because i dont usa fan, and work perfectly :) the MXL_pulley 2 have the distance between teeth 0.3mm down if you have problem with v1 try print v2
i have added a belt splitter too, if you dont like 10mm belt you can split into 7mm belt, just print the belt splitter(print 2 parts) , couple it and fit the belt into it, then insert a sharp, i have leaved 3 spaces for 5mm, 7mm and 9mm large belt.
you can use these 3 meters belt: http://goo.gl/yhyfp only 8â‚¬ :)
mission done :P
Liked ByView All
Give a Shout Out
30 teeth MXL plotter pulley up to 10mm belt for reprap by danithebest91 is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure danithebest91 would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).