by stevemedwin, published
I've been continuing my experiments with the "autobots" in Groboto. This thing ended up looking like an alien plant so I had to put it in a vase.
I used ReplicatorG on a MakerBot Replicator2 with the Replicator 2 slicing defaults and the following settings with white MB PLA:
Infill = 10%
Layer Height = 0.200
Shells = 1
Feedrate = 40
Travel Feed = 55
Temperature = 220
I used a raft with full support. ReplicatorG complained during the slicing but the build came out fine. The build took a little over 5 hrs.
Liked ByView All
Give a Shout Out
Alien Plant by stevemedwin is licensed under the Creative Commons - Attribution - Non-Commercial - No Derivatives license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is not allowed.
- Commercial use is not allowed.
We're sure stevemedwin would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).