threaded Spool mount for solidoodle
2
Likes
227
Downloads
320
Views
Published on February 24, 2013
Description
This is a replacement for the solidoodle spool mount. It's square threaded to allow you to tighten the spool. It uses 17mmx26mm x5mm bearings that fit inside the hat shaped piece. I used ABEC rated bearings, which make it spin with ease.
Print the Spool holder, 2 hats and a wingnut. put the 17mm bearings in the hats. Adapt to fit your spool.
Print the Spool holder, 2 hats and a wingnut. put the 17mm bearings in the hats. Adapt to fit your spool.
Instructions
Print the Spool holder, 2 hats and a wingnut. put the 17mm bearings in the hats. Adapt to fit your spool.
License
threaded Spool mount for solidoodle by heychris is licensed under the Attribution - Share Alike - Creative Commons license.
More from heychris
More from 3D Printer Accessories
You must be logged in to post a comment.