Geo Bracelet 01

by AK_Eric, published

Geo Bracelet 01 by AK_Eric Feb 24, 2013

Featured Thing!

Thing Info

14857Views 1798Downloads Found in Bracelets
Report Thing


Modeled in Maya while sitting at a coffee shop near Stanford (man did I feel like I fit some sort of stereotype). After working on "Geo Necklace 01", I wanted to try something slightly more complicated. This "bracelet" is two combined tori: The base is 8-sided, the top is 6-sided. No overhang issues, but I did have to pick out some interior loose filament. Spray-painted it two-tone blue/red.


Successfully printed in 'natural' PLA with "medium" settings in Makerware:
Extruded at 210, HBP off, no supports.
2 shells, 10% infill (presuming there is any infill at all).
Took 50 minutes to print, used 13g of PLA.

More from Bracelets

view more

Thing Info

14857Views 1798Downloads Found in Bracelets
Report Thing

Liked By

View All


Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Printed without Supports?

No supports: As long as your printer can do the bridging, the hexagonal shapes don't require them.

The back edge of this kept curling up. I printed with raft and it worked better.

what kind of spray did you use? Is it holding good on ABS? btw. thanks for nice model :)

I use different types Rust-Oleum spray, have always had good adhesion with them. FYI, I print mainly in PLA, but back when I used to print in ABS, the same paint seemed to stick just fine.

greetings fellow Maya modeler!

AK_Eric - in reply to

Hey, your QueenB house is great ;)