Missing plastic for 30pin adapter
by variador, published
This helps stabilize your iphone5 when you are using the 30pin to lightning adapter.
Ever feel uncomfortable when your iphone 5 has very little holding it in place during the use of the 30 pin to Lightning adapter? This is the missing piece of plastic the adds stability to the iphone 5 when using the adapter
After printing you have to remove the .8 mm piece of plastic that is in the way of where the phone goes. The thin wall of plastic is for support while printing. It removes easily with a razor cutter especially if you can cut the middle first. Sorry about this part but it makes for a good print.
It is a pretty tight fit when you put the adapter into the plastic piece. Once it is in I don't worry about it coming out.
Depending on your print tighten with tape or file a little out till it fits tight.
Liked ByView All
Give a Shout Out
Missing plastic for 30pin adapter by variador is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving variador a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure variador would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).