Hello Kitty Micro Cookie Cutter
4
Likes
177
Downloads
627
Views
Published on February 26, 2013
Derived from
paths2openscad Fedora 18 patch
by CryoFather
Description
The original picture was found on facebook.com/note.php?note_id=381737896739. The rest is just a little CAD/CAM alchemy.
Instructions
The cookie cutter diameter is roughly one inch (2.5 cm) in 1x version and two inches in 2x version. If your printer can do less than 0.3 mm layers with the 100 % width/height ratio, you can print this like a charm. Within minutes.
If you think I'm violating anything by creating a 3D cookie cutter from a Hello Kitty picture, please let me know. Enjoy it otherwise!
If you think I'm violating anything by creating a 3D cookie cutter from a Hello Kitty picture, please let me know. Enjoy it otherwise!
License
Hello Kitty Micro Cookie Cutter by CryoFather is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from CryoFather
More from Kitchen & Dining
You must be logged in to post a comment.