Leapfrog Creatr Z-hardstop glassplate saver
by zabana, published
So before to experience such a bad situation I worked on an easily piece wich prevents that kind of situation.
Recent Commentsview all
The yellow film is Kapton tape onto the glass. Now I use to cover it with a thin cape of abs+acetone.
Great solution, thx!. Can you tell me what the yellow plate is? My leapfrog has a glassplate where I stick a Avery sticker on it. Is this yellow a special cover/sticker to hold the object easy en losen it easy too? The problem with my sticker is that I had to replace it every 10 prints because than its damage because of the (to) good connection with the printed object.
Liked Byview all
Give a Shout Out
-Print the file
-Remove the back pannel
-Unscrew one z spindle bolt and pass it through the first hardstopper base hole and mid tight it
-Do the same with the second and secure it firmly
P.S: I printed mine at 0'3mm per layer, this piece doesnÃÂ´t need a big resolution.
You must be logged in to post a comment.