Thingiverse
3D Printing 3D Printer Accessories

RAMPS Box

Ultibots
505
Downloads
1218
Views
Published on February 27, 2013

Derived from

Ramps 1.4 Box
by oTTo

Description

Electronics Box for Arduino and RAMPS 1.4. The lid/top securely holds the sides together. This box is intended to be attached to the lower extrusion on the inside under the Y heat bed.

Visit ultibots.com for MendelMax Kits, Printed Parts, Filament, Electronics, and More...

Alibre PE Source Included.

Unfortunately I still have "rapid proto green" filament to use up - sorry :)

Instructions

Print & cleanup edges, file/sand round top slots...
Tags
This Thing has no tags.
Report as inappropriate

You must be logged in to post a comment.

anksoft on May 1, 2013 said:

would this work with SD card ramp?

Ultibots on May 1, 2013 said:

Not currently as the electronics slide into the box and the SD Card reader is attached off the side. You could modify the Alibre source to add an opening in the side wall. One that would permit the SD Card reader to be mounted after the electronics are in place. Thanks for your interest - Brad

hibijibi on March 31, 2013 said:

Do you have this mounted yet? Could you post pictures? I curious as to how you route wires from the x carriage to the underside of the y bed.

Collections

View all
MendelMax Parts
by arnebrys
rostock var.
by mchavez1961
MendelMax
by wassi

Remixes

Made

Liked by

View all

License

RAMPS Box by Ultibots is licensed under the Attribution - Share Alike - Creative Commons license.

More from Ultibots

More from 3D Printer Accessories

⇪